User's Manual

Chapter 4 - Operation and Administration
BreezeACCESSS VL System Manual
4-12
Set Defaults:
The Set Defaults submenu enables reverting the system parameters to a
predefined set of defaults. There are two sets of default configurations:
A. Factory Defaults: This is the standard default configuration.
B. Operator Defaults: Operator Defaults configuration can be defined
by the Administrator using the Save Current Configuration As
Operator Defaults option in this menu. It may also be defined at the
factory according to specific operator's definition. The default
Operator Defaults configuration is the Factory Defaults
configuration.
The current configuration file and the Operator Defaults configuration
file can be uploaded/downloaded by the unit using FTP. For more
information, see Configuration File Upload/Download
option on
page 4-18. These files can also be uploaded/downloaded remotely using
TFTP (see Appendix B - File Download and Upload Using TFTP
).
The available options in the Set Defaults submenu are:
! Set Complete Factory Defaults
! Set Partial Factory defaults
! Set Complete Operator Defaults
! Set Partial Operator defaults
! Cancel Current Pending Request
Set Complete Factory Defaults
Select this option to reset the unit to the standard Factory Defaults
configuration, excluding several parameters that are listed in Table 4-2.
Table 4-2: Parameters not reset after Set Complete Factory/Operator Defaults
Parameters Group Parameter
All Passwords
FTP Server IP address
FTP Gateway IP address
FTP Client IP address
FTP Client IP Mask
Unit Control Parameters
FTP User Name