User's Manual

Configuring Basic Parameters
Manual Revision 1.0
3-3
Table 3-1: Basic Parameters
Parameter Default Value Comment
Tx Power for Modulation Levels 1
to 5
Tx Power for Modulation Level 6
Tx Power for Modulation Level 7
Tx Power for Modulation Level 8
(HW Revision B only)
Depend on HW revision,
unit type and Sub Band
Tx Power cannot be
higher than the applicable
Maximum Tx Power
parameter.
Maximum Tx Power for Modulation
Levels 1 to 5 (SU)
Maximum Tx Power for Modulation
Level 6 (SU)
Maximum Tx Power for Modulation
Level 7 (SU)
Maximum Tx Power for Modulation
Level 8 (SU, HW Revision B only)
Depend on HW revision
and Sub Band
Max Tx Power cannot be
higher than the upper
limit according to the Sub
Band in use.
Antenna Gain (units with external
antenna)
According to the antenna
supplied with the unit and
the Sub Band.
If set to “Not Set Yet”,
must be configured
according to actual value,
taking into account
cable’s attenuation.
ATPC Option Enable
Best AU Support (SU) Disable
Preferred AU MAC Address (SU) 00-00-00-00-00-00 (none) Applicable only when
Best AU Support is
enabled
Cell Distance Mode (AU) Automatic
Maximum Cell Distance (AU) 0 (No Compensation)
Maximum Modulation Level (SU) 8 (or the highest value
supported according to
the country code). Not
higher than 7 for units
with HW revision A.
Refer to Configuring the
Subscriber Unit's
Maximum Modulation
Level on page 3-7