User's Manual

Installing the Modular Base Station Equipment
Manual Revision 1.0
2-21
C. Connect the shield to the ground.
9. If a BS-PS-AC-VL power supply is used, connect the AC power cord
to the AC In jack of the BS-PS-AC-VL power supply. If a redundant
power supply module is installed, connect an AC power cord also to
the second AC power module. Connect the power cord(s) to the
mains outlet.
10. Switch the BS-PS-AC/DC-VL power supplies to ON. Verify that all
power indicator LEDs on the BS-PS-AC/DC-VL front panel are ON
and that the OVERTEMP alarm indicator is off. Refer to Table 2-2 on
page 2-17 for a description of these LEDs.
11. Configure the basic parameters in all BS-AU modules as described
in Configuring Basic Parameters on page 3-2.
12. Connect the 10/100 BaseT LAN connector(s) to the network. The
cable connection should be straight Ethernet if connecting the
indoor unit to a Hub/Switch and a crossed cable if connecting it
directly to a PC Network Interface Card (NIC).
NOTE
The length of each of the Ethernet cables (the cable connecting the indoor unit to the
user's equipment and the Indoor-to-Outdoor cable) should not exceed 100 meters.
NOTE
Reset the unit using the RESET push button after connecting or reconnecting the indoor
and outdoor units with the indoor-to-outdoor cable.