User's Manual

Installing the Modular Base Station Equipment
Manual Revision 1.0
2-19
BS-AU Network Interface Module
The front panel of the BS-AU Access Unit Network Interface module is
shown in Figure 2-10.
Figure 2-10: BS-AU Front Panel
The BS-AU provides the following interfaces:
! 10/100 BaseT: A 10/100BaseT Ethernet connector for connecting
the BS-AU to the network. A straight Ethernet cable should be used
to connect the module to a hub, router or switch.
! RADIO: A 10/100BaseT Ethernet connector for connecting the
BS-AU to an AU-ODU outdoor unit.
The recessed RESET switch on the front panel is for resetting the
outdoor unit.