User's Manual

Chapter 2 - Installation
BreezeACCESSS VL System Manual
2-14
1. Connect the Indoor-to-Outdoor cable to the RADIO connector,
located on the front panel of the indoor unit.
2. Connect the power cord to the unit's AC socket, located on the rear
panel. Connect the other end of the power cord to the AC mains.
The unit can operate with AC mains of 100-240 VAC, 50-60 Hz.
NOTE
The color codes of the power cable are as follows:
Brown Phase ~
Blue Neutral 0
Yellow/Green Ground
3. Verify that the POWER LED (located on the front panel of the
PS1036 and on the top panel of the PS1073) is lit, indicating that
power is supplied to the unit.
4. Configure the basic parameters as described in Configuring Basic
Parameters on page 3-2.
5. Connect the 10/100 BaseT ETHERNET connector (located on the
front panel of the PS1036 and or the side panel of the PS1073) to
the network. The cable connection should be a straight Ethernet if
connecting the indoor unit to a Hub/Switch and a crossed cable if
connecting it directly to a PC Network Interface Card (NIC).
NOTE
The length of the Ethernet cable connecting the indoor unit to the user's equipment,
together with the length of the Indoor-to-Outdoor cable, should not exceed 100 meters.
NOTE
Reset the unit using the RESET recessed push button after connecting or reconnecting
the indoor and outdoor units with the indoor-to-outdoor cable.
To install the IDU: