User's Manual

Specifications
Manual Revision 1.0
1-13
Table 1-5: Radio Specifications
Item Description
Max. Input Power
(at antenna port)
HW Rev. A: -48dBm typical
HW Rev. B: -30dBm typical
Maximum Output Power
2
21 dBm
Modulation
Level
3
Sensitivity
(HW Rev. A)
Sensitivity
(HW Rev. B)
Min. SNR
1 -87 dBm -89 dBm 6 dB
2 -86 dBm -88 dBm 7 dB
3 -85 dBm -86 dBm 9 dB
4 -83 dBm -84 dBm 11 dB
5 -80 dBm -81 dBm 14 dB
6 -76 dBm -77 dBm 18 dB
7 -71 dBm -73 dBm 22 dB
Sensitivity, typical (dBm at
antenna port, PER<10%)
8
4
-69 dBm -71 dBm 23 dB
Modulation OFDM modulation, 64 FFT points; BPSK, QPSK, QAM16,
QAM64
1
The actually available frequency channels and bandwidth are defined by the selected Sub-Band,
which reflects the applicably regulatory constraints. For more details refer to Show Country Dependent
Parameters on page 4-9.
2
The actually available maximum output power for each modulation level is defined by the selected
Sub-Band, which reflects the applicably regulatory constraints. . For some countries the power may
also be limited by limitations on the maximum EIRP (also included in the Sub-Band parameters) and
the Antenna Gain parameter. For more details refer to Show Country Dependent Parameters
on page
4-9 and to Transmit Power
on page 4-51. For information on specific HW and Country Code
limitations, see the Country Codes document.
3
Modulation Level indicates the radio transmission rate and the modulation scheme. Modulation Level
1 is for the lowest radio rate and modulation scheme.
4
Modulation Level 8 is supported only in unit with HW Revision B and above.