User's Manual

Appendix E - Supported MIBs and Traps
BreezeACCESSS VL System Manual
E-30
Table E-11: Performance Parameters
MIB Parameter Description Value/Range
*MinimumIntervalBetweenAdaptiveModulation
AlgorithmMessages
(*AdaptiveModulationParams 4)
Applicable to all units. The
minimum interval between
two consecutive adaptive
modulation algorithm
messages carrying
information on the SNR of
received signals.
Integer
1-3600 (seconds)
*BurstMode
(*PerformanceParams 10)
Burst Mode Parameters.
Applicable to all units.
*BurstModeOption
(*BurstMode 1)
Applicable to all units.
Applicable only if Burst Mode
Option is supported by the
Sub Band. Enabling/disabling
burst mode operation. In SU
blocked (3) value is returned
when Security Mode is WEP ,
Data Encryption Option is
Enabled and Burst option is
Enabled. In AU blocked(3)
value is returned when DFS
Option is Enabled and Burst
mode Enabled
Integer
disable (1)
enable (2)
blocked (3)
na (255)
*BurstInterval
(*BurstMode 2)
Applicable to all units. The
burst interval in milliseconds.
Integer
1-the maximum
value as defined in
the Sub Band.
(milliseconds)
na (255)
Site Survey Parameters
Table E-12: Site Survey Parameters
MIB Parameter Description Value/Range
*SiteSurvey
(breezeAccessVLMib 11)
*AverageReceiveSNR
(*SiteSurvey 1)
Applicable to SU/RB. Read-
only. The average Signal to
Noise Ratio of received frames.
Integer
*TrafficStatistics
(*SiteSurvey 2)
Applicable to all units. Traffic
statistics parameters.
*ResetTrafficCounters
(*TrafficStatistics 1)
Applicable to all units. Resets
the traffic counters.
Integer
reset (1)
cancel (2)
*EthCounters
(*TrafficStatistics 2)
Applicable to all units. Ethernet
counters.
*TotalRxFramesViaEthernet
(*EthCounters 1)
Applicable to all units.
Read-only. Total number of
frames received via the
Ethernet port.
Counter 32