User's Manual

breezAccessVLMib
Manual Revision 1.0
E-29
Table E-11: Performance Parameters
MIB Parameter Description Value/Range
*MaximumModulationLevel
(*PerformanceParams 5)
Applicable to all units. If the
Adaptive Modulation
algorithm is enabled, it sets
the maximum modulation
level to be used. If The
Adaptive Modulation
algorithm is disabled, it set
the fixed modulation level to
be used.
Integer
Range: 1 to 8*
*Range depends
on HW version
and Min/Max
Modulation Levels
as defined by Sub
Band.
*MulticastModulationLevel
(*PerformanceParams 6)
Applicable to AU/BU. The
modulation level for multicast
and broadcast data frames.
Integer
Range: 1 to 8*
*Range depends
on HW version
and Min/Max
Modulation Levels
as defined by Sub
Band.
*AvgSNRMemoryFactor
(*PerformanceParams 7)
Applicable to all units. The
weight of history in average
RSSI calculation for the ATPC
(AU only) and Adaptive
Modulation algorithm. The
higher is the value, the higher
is the weight of history
DisplayString
-1 (Disregard
History) to 32
*HardwareRetries
(*PerformanceParams 8)
Applicable to all units. The
maximum number of trials to
transmit an unacknowledged
frame in each Hardware
Retrials phase.
Integer
1-15
*AdaptiveModulationParams
(*PerformanceParams 9)
Adaptive Modulation
Parameters
*AdaptiveModulationAlgorithmOption
(*AdaptiveModulationParams 1)
Applicable to all units.
Enabling/disabling the
Adaptive Modulation
algorithm.
Integer
disable (1)
enable (2)
*SoftwareRetrySupport
(*AdaptiveModulationParams 2)
Applicable to all units.
Read-only for units with
version 2.0 and above.
The status of the Software
Retry mechanism.
Enabled when the Adaptive
Modulation algorithm is
enabled and the Burst Mode
Option is disabled. Otherwise
it is disabled.
Integer
disable (1)
enable (2)
na (255)
*NumberOfSoftwareRetries
(*AdaptiveModulationParams 3)
Applicable to all units.
Read-only for units with
version 2.0 and above.
The maximum number of
times to use the Software
Retry mechanism when it is
enabled.
Integer
0-14