User's Manual

breezAccessVLMib
Manual Revision 1.0
E-21
Table E-7: Air Interface Parameters
MIB Parameter Description Value/Range
*CurrentFrequencySubsetTable
(*FrequencyDefinition 6)
Applicable to all units. Not
accessible. The Current
Frequency Subset table that
includes all frequencies that
are currently used for
scanning.
*CurrentFrequencySubsetEntry
(CurrentFrequencySubsetTable 1)
Applicable to all units. Not
accessible. An entry in the
Current Frequency Subset
table.
*CurrentFrequencySubsetTableIdx
(*CurrentFrequencySubsetEntry 1)
Applicable to all units. Read-
only. The index of an entry
in the Current Frequency
Subset table.
Integer
*CurrentFrequencySubset
Frequency
(*FrequencySubsetEntry 2)
Applicable to all units. Read-
only. The frequency of an
entry in the Current
Frequency Subset table.
Integer
*CurrentAUOperatingFrequency
(*FrequencyDefinition 7)
Applicable to AU/BU. The
operating frequency.
Integer
For 5.8GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using 10MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub
Band.
*DefinedAUDefinedFrequency
(*FrequencyDefinition 8)
Applicable to AU/BU. For
5.8GHz products with SW
version below 2.0 this is the
read-only frequency of the
AU/BU after the next reset.
For units with SW version
2.0 and up this is the
frequency to use when the
DFS Option is disabled.
Integer
For 5.8GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using 10MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub
Band.
*CurrentSUOperatingFrequency
(*FrequencyDefinition 9)
Applicable to SU/RB. Read
only. The current operating
frequency.
Integer
For 5.8GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using 10MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub
Band.
*SubBandSelect
(*FrequencyDefinition 10)
Sub Band Selection
parameters
*SelectSubBandIndex
(*SubBandSelect 1)
Applicable to all units. The
ID of the sub-band used by
the unit.
Integer
*DFSParameters
(*FrequencyDefinition 11)
DFS Parameters. Applicable
to AU/BU.
*DFSOption
(*DFSParameters 1)
Applicable to AU/BU.
Enabling/disabling the DFS
Algorithm. Not applicable if
DFS Option is not supported
by the current Sub Band.
Integer
disable (1)
enable (2)
na (255)