User's Manual

breezAccessVLMib
Manual Revision 1.0
E-7
Table E-3: Unit Control Parameters
MIB Parameter Description Value/Range
*FlashMemoryControl
(*UnitControl 4)
Applicable to all units.
Reset And Boot From
Shadow Version:
Activates the shadow
version.
Use Running Version
After Reset: The currently
active version will become
the main version and will
be activated after next
reset.
Integer
resetAndBootFrom
ShadowVersion (1)
useRunningVersion
AfterReset (2)
cancel (3)
*TelnetLogoutTimer
(*UnitControl 5)
Applicable to all units.
Time-out of management
via Telnet. Automatic exit
if the program is inactive
for the defined time.
Integer
1-999 (minutes)
*SaveCurrentConfigurationAs
OperatorDefaults
(*UnitControl 6)
Applicable to all units.
Saves the current
configuration as Operator
Defaults.
Integer
saveAsDefaults (1)
cancel (2)
*ExitTelnet
(*UnitControl 7)
Applicable to all units. Exit
the Telnet Monitor
session.
Integer
cancelOperation (1)
exit (2)
*UnitPasswords
(*UnitControl 8)
Applicable to all units.
Unit passwords.
*ReadOnlyPassword
(*UnitPasswords 1)
Applicable to all units. The
User (read only)
password.
DisplayString (SIZE(8)).
Up to 8 printable ASCII
characters.
*InstallerPassword
(*UnitPasswords 2)
Applicable to all units. The
Installer password.
DisplayString (SIZE(8)).
Up to 8 printable ASCII
characters.
*AdminPassword
(*UnitPasswords 3)
Applicable to all units. The
Administrator password.
This is also the SNMP
Write Community String.
DisplayString (SIZE(8)).
Up to 8 printable ASCII
characters.
*EthernetNegotiationMode
(*UnitControl 9)
Applicable to all units.
Ethernet port mode of
operation.
Integer
force10MbpsAnd
HalfDuplex (1)
force10MbpsAnd
FullDuplex (2)
force100MbpsAnd
HalfDuplex (3)
force100MbpsAnd
FullDuplex (4)
autoNegotiationMode (5)
*FTPParameters
(*UnitControl 10)
Applicable to all units.
FTP parameters
*FTPServerParams
(*FTPParameters 1)
Applicable to all units.
General FTP server
parameters.
*FTPServerUserName
(*FTPServerParams 1)
Applicable to all units. The
user name to be used for
access to the FTP server
DisplayString (SIZE(20)).
Up to 18 printable ASCII
characters.
*FTPServerPassword
(*FTPServerParams 2)
Applicable to all units. The
password to be used for
access to the FTP server
DisplayString (SIZE(20)).
Up to 18 printable ASCII
characters.