User's Manual

Appendix C - Using the Set Factory Defaults Utility
BreezeACCESSS VL System Manual
C-2
The Set Factory Defaults utility is intended to enable management
access to a unit in cases where such access is not possible due to wrong
or unknown configuration of certain parameters. This includes cases
such as unknown Management VLAN ID and wrong management
access filtering.
The utility accesses the unit by sending a special packet. Access to the
unit is based on its MAC address, which must be entered in the Unit
MAC address field.
The set unit defaults feature is only available via the Ethernet port.
1. Connect the PC with the Set Factory Defaults utility to the Ethernet
port of the unit.
2. Enter the unit’s MAC address.
3. Click on the Set button.
This utility performs the same operation as Set Complete Factory
Defaults, restoring the default factory configuration of all parameters,
except to Passwords, general FTP parameters and AU’s Frequency.
To set factory defaults: