User's Manual

Chapter 4 - Operation and Administration
BreezeACCESSS VL System Manual
4-84
Service Parameters
The Service Parameters menu enables defining user filtering and
MIR/CIR parameters.
The Service Parameters menu includes the following parameters:
! User Filtering Parameters (SU only)
! MIR and CIR Parameters
User Filtering Parameters (SU only)
The User Filtering Parameters submenu enables defining the IP
addresses of user devices authorized to access the wireless media for
security and/or control purposes. In addition, it can be used to enable
the transmission and reception of specific protocol frames. These
filtering options do not affect management frames sent to or generated
by the unit.
The User Filtering Parameters menu provides the following options:
User Filtering Option
The User Filtering Option disables or enables the User Filtering feature.
The following options are available:
! Disable, which means no filtering.
! IP Protocol Only, which means only IP Protocol packets pass.
! User Defined Addresses Only, which means only IP frames from/to
IP addresses included in the User Filter Addresses list pass.
! PPPoE Protocol Only, which means only PPPoE messages pass
(Ethernet type 0x8863 and 0x8864).
The default selection is Disable.
Set User Filter Address
The Set User Filter Address option enables entering up to 8 IP
addresses from/to which IP frames are to pass if the User Defined
Addresses Only option is selected in the User Filtering Option
parameter.
The default for all addresses is 0.0.0.0.