User's Manual

Chapter 4 - Operation and Administration
BreezeACCESSS VL System Manual
4-60
Network Management Filtering
The Network Management Filtering option enables or disables the IP
address based management filtering. If management filtering is enabled,
the unit can only be managed by stations with IP addresses matching
one of the entries in the Set Network Management IP Addresses option,
described below, and that are connected to the unit via the defined
port(s). The following options are available:
! Disable: No IP address based filtering is configured.
! Activate IP Filter on Ethernet Port: Applicable only if the Access
to Network Management parameter is configured to either From
Ethernet Only or From Both Ethernet and Wireless Link. The unit
can be managed from the Ethernet port only by stations with IP
addresses matching one of the entries in the Set Network
Management IP Addresses parameter. If the Access to Network
Management parameter is configured to From Both Ethernet and
Wireless Link then no IP address based filtering is configured for the
wireless port.
! Activate IP Filter on Wireless Link Port: Applicable only if the
Access to Network Management parameter is configured to either
From Wireless Link Only or From Both Ethernet and Wireless Link.
The unit can be managed from the wireless port only by stations
with IP addresses matching one of the entries in the Set Network
Management IP Addresses parameter. If the Access to Network
Management parameter is configured to From Both Ethernet and
Wireless Link then no IP address based filtering is configured for the
Ethernet port.
! Activate IP filter on Both Ethernet and Wireless Link Ports:
Applicable to all options of the Access to Network Management
parameter. The unit can be managed from the port(s) defined by the
Access to Network Management parameter only by stations with IP
addresses matching one of the entries in the Set Network
Management IP Addresses parameter.
The default selection is Disable.
Set Network Management IP Address
The Set Network Management IP Address option enables defining up
to 10 IP addresses of devices that can manage the unit if the Network
Management Filtering option is enabled.
The default Network Management IP Address is 0.0.0.0 (all 10
addresses)