User's Manual

Chapter 4 - Operation and Administration
BreezeACCESSS VL System Manual
4-46
After country code learning (adaptation) the unit is automatically reset.
Before this automatic reset, if the unit is running from shadow version,
the versions must be swapped and the running version must be set as
main. This is done to avoid returning to the previous version, which
shall happen automatically after the reset.
The default is Enable.
Show Frequency definitions
Upon selecting Show Frequency Definitions, the selected Sub Band and
Frequency are displayed. In addition, all the parameters displayed upon
selecting Show DFS Settings and Data are also displayed.
Frequency Definition Submenu in SU
Sub Band Select
This parameter is available only if the country code supports two or
more Sub Bands. For information on how to view the Sub Bands
supported by the unit and the supported parameters’ values and
options, refer to Show Country Dependent Parameters
on page 4-9.
The range depends on the number of Sub Bands supported by the
country code.
The default selection is Sub Band 1.
Frequency Subset Definition
The Frequency Subset Definition parameter defines the frequencies that
will be used in by the SU when scanning for an AU. The available
frequencies according to the Sub Band are displayed, and each of the
frequencies in the list is associated with an index. The frequencies
subset can be defined by entering the indexes of the required
frequencies, or “A” to select all available frequencies.
The default is the complete list of frequencies available in the Sub Band.
Show Frequency Definitions
Upon selecting the Show Frequency Definitions, the selected Sub Band
parameters and the current operating frequency will be displayed. The
current defined frequency subset as well as the defined subset (to be
used after the next reset) are also displayed.