User's Manual

Menus and Parameters
Manual Revision 1.0
4-45
Clear Radar Detected Channels After Reset
When the Clear Radar Detected Channels After Reset is enabled, than
after the next reset all viable frequencies will be marked in the database
as Radar Free, including frequencies previously marked as either Radar
Detected or Adjacent to Radar. In addition, the AU will start operation
using its default frequency.
The default is Disable.
Show DFS Settings And Data
Upon selecting the Show DFS Settings and Data, the values of all DFS
parameters and the current operating frequency will be displayed. The
current defined frequency subset as well as the defined subset (to be
used after the next reset) are also displayed. In addition, all the
applicable frequencies will be displayed together with their status in the
database (Radar Free, Radar Detected or Adjacent to Radar).
Country Code Learning by SU
This feature support simplified installation and updates processes by
enabling the SU to adapt the Country Code used by the AU.
The AU advertises its country code in every beacon and association
response message. Upon synchronization the SU shall check if its
country code and the country code received from the AU are the same.
If they are not the same and the Country Code Learning by SU is
enabled, the SU shall use the AU’s country code: the country code
derived limitations shall be forces and the following parameters shall be
set according to new country definitions:
! Maximum TX Power (per modulation level) shall be set to the
maximum defined by country code.
! TX Power (per modulation level) shall be set to the maximum defined
by country code.
! The Modulation Level shall be set to the maximum modulation level
defined by country code.
! The Multicast Modulation Level shall be set to the minimum
modulation level defined by country code.
! The Burst Mode shall be set to enable if the country code supports
burst mode, and the burst duration shall be set to default.