User's Manual

Appendix A
SU-I-D Installation Manual 34 BreezeACCESS-MMDS Series
directional amplifier should be installed with the connectors facing downward.
After placing the assembly on the mast, use an open-end wrench to carefully
tighten the nuts. Take care not to over-tighten the nuts or you may inadvertently
strip the threads.
Figure A-6. AMP 2440 Installation and Mounting
WARNING! It is very important to waterproof the RF connectors on the AMP
2440 bi-directional amplifier.
However, it is recommended that you do not seal the connectors until after all
system tests have been performed. Be sure to use the high quality weather
resistant vapor wrap included with you amplifier kit to seal all the outside
connections.
The DC Power Injector is not in a waterproof enclosure and must be protected
from the weather. It can be permanently mounted to a surface using the mounting
flanges.
Note: When using the 24dB gain dish antenna in the United States, the external
filter (P/N: SPF-1) must be installed to comply with FCC emission
requirements.