User's Manual

Configuring System Parameters
SU-I-D Installation Manual 14 BreezeACCESS-MMDS Series
7. Type 9 to access the Hopping Set selection screen. Enter the required
hopping set (AU-I units only).
8. Type G to access the Transmit Antenna selection screen. Enter the required
selection (0 - use two antennas, 1 - use antenna #1, 2 - use antenna #2).
3.3 Reset Unit
1. From the main menu, type 2 to access the Unit Control menu.
2. Type 1 to access the Reset Unit menu. Type 1 to reset the unit so that new
configuration settings are applied.
Note: Should you make any mistakes during configuration or encounter any
problems associated with system configuration parameters, you may
configure the unit back to the factory defaults, as follows:
Type 2 in the Unit Control menu to access the Set Factory Defaults menu.
Type in 2 (Set Factory defaults-Full) to load the default values. Reset the
unit for the factory defaults values to take effect.