User's Manual

Configuring System Parameters
BreezeACCESS MMDS Series 13 SU-I-D Installation Manual
1. From the main menu, type 3 to access the Basic Configuration menu.
BreezeACCESS (AU-I)
Official Release Version – 2.2.6
Release Date: Mon Apr 24 21:52:01 2000
Basic Configuration
====================
1 – IP Address
2 – Subnet Mask
3 – Default Gateway Address
4 – ESSID
5 – Maximum Data Rate
6 - Frequency Offset
7 – Hopping Shift
8 – Hopping Sync
9 - Hopping Set
A - Power Level
G – Transmit Antenna
S - Show Basic Configuration
BreezeACCESS >>>
Figure 3-2. Basic Configuration Menu
2. From the Basic Configuration menu, type 4 to access the ESSID selection
screen. Enter the required ESSID.
3. Type 1 to access the IP Address selection screen. Enter the required IP
address.
4. Type 2 to access the Subnet Mask selection screen. Enter the required subnet
mask.
5. Type 3 to access the Default Gateway Address selection screen. Enter the
required default gateway address.
6. Type 7 to access the Hopping Shift selection screen. Enter the required
Hopping Shift (AU-I units only).