User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 495 System Manual
* After configuring at least one general BS parameter (see “Managing BS General
Parameters” on page 498), even when configured to its default value, all tables
with no mandatory parameters are created automatically, with all parameters set
to their default value. Otherwise, for each of the following tables you must enter
the configuration mode and execute the Apply command before exiting the
configuration mode:
“Managing BS Bearer Interface
Parameters” on page 589
ip-address
ip-subnetmask
dflt-gw
No
“Managing Authentication Relay
Parameters” on page 592
dflt-auth-ip-address No
“Managing Bearer Traffic QoS Marking
Rules” on page 598
enable-srvcflow-mediaflowtype
srvcflow-mediaflowtype (if
enable-srvcflow-mediaflowtype is set to
True)
Yes
“Managing Control Traffic QoS Marking
Rules” on page 606
No*
“Managing ID-IP Mapping Parameters”
on page 615
nw-node-id (Next Hop BS ID)
nw-node-ip
No
“Managing Ranging Parameters” on
page 619
No*
“Managing Alarm Threshold Parameters”
on page 623
No
“Managing BS Reserved Parameters” on
page 628
No
“Managing the BS Keep-Alive
Functionality” on page 628
No
“Managing the BS Idle Mode
Parameters” on page 632
No
“Managing Scheduler Parameters” on
page 634
No
“Managing the BS ASN-GW Load
Balancing Parameters” on page 639
No
“Managing Beam Forming Parameter” on
page 642
No
Table 3-28: Tasks for Configuring a BS
Task Mandatory Parameters apply required