User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 493 System Manual
3.9 Managing BSs
Up to 28 different BSs can be defined.
The full configuration of each BS includes multiple components (tables). Many of
these tables include one or more mandatory parameters (parameters with no
default value). The creation of a new BS is not completed until all mandatory
parameters have been configured.
Due to the complicated structure of the BS object and the high number of
mandatory parameters in different tables, a special apply command must be
executed for properly completing the configuration of certain tables. The apply
command must be executed before exiting the applicable configuration mode.
Failure to execute the apply command will result in loss of the newly configured
parameters. Wherever required, the need to use the apply command will be
indicated in the manual.
The following table lists the tasks for configuring a BS, indicating the applicable
mandatory parameters and the need to execute the apply command where
applicable. When configuring a new BS, verify that all mandatory parameters have
been configured (otherwise a trial to associate the BS to a Sector will fail):
Table 3-28: Tasks for Configuring a BS
Task Mandatory Parameters apply required
“Enabling the BS Configuration
Mode\Creating a BS Object” on
page 496
bs id No
“Managing BS General Parameters” on
page 498
No
“Managing Power Control Levels” on
page 506
No*
“Managing BS Feedback Allocation
Parameter” on page 519
No
“Managing Neighbor Advertisement
Parameters” on page 521
No
“Managing Triggers Parameters” on
page 524
No
“Managing Scan Negotiation
Parameters” on page 528
No