User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing Antennas
4Motion 486 System Manual
 Configure one or more of the parameters of the Antenna (refer to Section 3.8.2)
 Restore the default value of the non-mandatory parameters parameter (refer to
Section 3.8.3)
After executing the above tasks, you can terminate the Antenna configuration
mode (refer to Section 3.8.4) and return to the global configuration mode.
3.8.2 Configuring Antenna Parameters
After enabling the Antenna configuration mode you can configure the Antenna
parameters.
To configure the Antenna parameters, run the following command:
npu(config-antenna-1)# params [antenna-type <string (32)>] [no-of-ports <(1 to 8
StepSize 1)>] [mechanical-downtilt <(-90 to 90 StepSize 0.1)>] [electrical-downtilt
<(-90 to 90 StepSize 0.1)>] [longitude <longitude>] [latitude <latitude>]
[tower-height <(0 to 500 StepSize 1)>] [heading <(0 to 359 StepSize 1)>] [cable-loss
<(0 to 20 StepSize 0.1)>] [antenna-product-id {<a list of default and standard
antennas> } ]
Command
Syntax
npu (config)# antenna <(1 to 28 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 28 StepSize 1)> The Antenna number Mandatory N/A 1-28
Command
Modes
Global configuration mode
NOTE
The following examples are for antenna-1 configuration mode.