User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing ODUs
4Motion 483 System Manual
In addition to the configurable parameters, the following status parameters are
also displayed:
ODU Status Mask is a decimal number representing the value of a 32-bits mask
indicating possible failures, as follows:
Command
Modes
Global command mode
Parameter Description Possible Values
HWVersion HW version no. of ODU basic card connected to
this port
<number>
HWRevision HW revision no. of ODU basic card connected to
this port
<number>
HPACard Indicates whether the port is connected to an
HPA card
 installed (1)
 notInstalled (0)
HPAHWVersion HW version no. of HPA connected to this port
(relevant only if HPACard is installed)
<number>
HC08SWVersion SW version of HC08 controlling card connected
to this port
<string>
CPLDSWVersion SW version of CPLD controlling card connected
to this port
<string>
SerialNumber Serial number of ODU basic card connected to
this port
<number>
txpower-status The operation status of the port <enabled/disabled>
odu-status-mask Status indication (see below) <number>
RSSI Average uplink RSSI in dBm of all bursts of all
connected MSs.
<number>
bit set to 1 Failure
None No Failure
1 AU Communication with ODU was lost
2 An error was detected while downloading a table to the ODU
3 The ODU temperature is high
4 Not used
5 Not used