User Manual
Chapter 3 - Operation and Administration of the Macro BTS Managing ODUs
4Motion 479 System Manual
3.7.2.3 Restoring Default Values for ODU Port Parameters
After enabling the ODU Port configuration mode you can restore the default
values for the txpower-onoff parameter:
NOTE
You can display configuration information for the ODU Port parameters. For details, refer to
Section 3.7.2.6.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-odu-port-1-1)# params [txpower <(0 to 46 StepSize 1)>]
[txpower-onoff {on | off} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[txpower <(0 to 46
StepSize 1)>]
The transmit power at the
ODU Port, in dBm.
Optional As
configured
previously
0 to 46 in
increments of 1
Actual range
depends on ODU
type.
[txpower-onoff {on
| off} ]
Enables or disables
transmissions on this port.
Optional on
on
off
Command
Modes
odu-port configuration mode
IMPORTANT
Do not disable transmission on any of the ODU ports. If needed, transmission can be disabled by
shutting down the applicable AU port (see Section 3.6.2.1).