User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 406 System Manual
3.4.15 Configuring the SNMP/Trap Manager
This section describes the commands for:
 “Configuring the SNMP Manager” on page 406
 “Configuring the Trap Manager” on page 409
3.4.15.1 Configuring the SNMP Manager
To enable 4Motion configuration over SNMP, you are required to first configure
the SNMP Manager. You can configure up to five SNMP Manager entries for the
4Motion system, where each entry is uniquely identified by the pair of values for
the Read Community and Write Community. This section describes the
commands to be executed for:
 “Adding an SNMP Manager” on page 406
 “Deleting an Entry for the SNMP Manager” on page 407
 “Displaying Configuration Information for SNMP Managers” on page 408
3.4.15.1.1 Adding an SNMP Manager
You can configure upto five SNMP Managers. To add an SNMP Manager, run the
following command:
npu(config)# snmp-mgr [ReadCommunity <string>] [ReadWriteCommunity
<string>]
You can display configuration information for existing SNMP Managers. For
details, refer Section 3.4.15.1.3.
Command
Modes
Global command mode
NOTE
An existing SNMP Manager entry cannot be modify. To modify the parameters of an SNMP
Manager, delete the entry and add a new entry with the required parameters.