User Manual
Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 405 System Manual
3.4.14.3 Displaying the Status of Performance Data Collection
To display whether collection and storage of performance data is enabled/disabled
for a group, run the following command:
To display the status for an NPU counters group:
npu# show npu pm-group status {BckhlPort | CascPort | IntMgmtIf |
ExtMgmtIf | BearerIf | R6InterfaceTotal | R6InterfaceBs |
ProvisionedQOS | R3Interface | LoadBalancing | InitialNe}
To display the status for an AU counters group:
npu# show au pm-group status { BsIntegrity | BsTrafficTable |
BsUtilizationTable | BsTxR1TotalTrafficTable |
BsRxR1TotalTrafficTable | BsGeneral | BsAllMsBasicMode}
Command
Syntax
npu(config)# no pm-group enable npu {BckhlPort | CascPort | IntMgmtIf |
ExtMgmtIf | BearerIf | R6InterfaceTotal | R6InterfaceBs | ProvisionedQOS
| R3Interface | LoadBalancing | InitialNe}
npu(config)# no pm-group enable au { BsIntegrity | BsTrafficTable |
BsUtilizationTable | BsTxR1TotalTrafficTable | BsRxR1TotalTrafficTable | BsGeneral |
BsAllMsBasicMode}
Privilege
Level
10
Command
Modes
Global configuration mode
Command
Syntax
npu# show npu pm-group status {BckhlPort | CascPort | IntMgmtIf | ExtMgmtIf | BearerIf |
R6InterfaceTotal | R6InterfaceBs | ProvisionedQOS | R3Interface | LoadBalancing | InitialNe}
npu# show au pm-group status { BsIntegrity | BsTrafficTable | BsUtilizationTable |
BsTxR1TotalTrafficTable | BsRxR1TotalTrafficTable | BsGeneral | BsAllMsBasicMode}
Privilege
Level
1
Display
Format
<Group Name> <Status>