User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration

4Motion 404 System Manual

3.4.14.2 Disabling Collection and Storage of Performance Data

To disable collection and storage of performance data for one group, run the

following command:

To disable collection and storage of performance data for an NPU counters group:

npu(config)# no pm-group enable npu {BckhlPort | CascPort |

IntMgmtIf | ExtMgmtIf | BearerIf | R6InterfaceTotal | R6InterfaceBs

| ProvisionedQOS | R3Interface | LoadBalancing | InitialNe}

To disable collection and storage of performance data for an AU counters group:

npu(config)# no pm-group enable au { BsIntegrity | BsTrafficTable |

BsUtilizationTable | BsTxR1TotalTrafficTable |

BsRxR1TotalTrafficTable | BsGeneral | BsAllMsBasicMode}

For example, run the following command if you want to disable performance data

collection and storage for the Load Balancing function:

npu(config)# no pm-group enable npu LoadBalancing

Command

Syntax

npu(config)# pm-group enable npu {BckhlPort | CascPort | IntMgmtIf |

ExtMgmtIf | BearerIf | R6InterfaceTotal | R6InterfaceBs | ProvisionedQOS

| R3Interface | LoadBalancing | InitialNe}

npu(config)# pm-group enable au { BsIntegrity | BsTrafficTable | BsUtilizationTable |

BsTxR1TotalTrafficTable | BsRxR1TotalTrafficTable | BsGeneral | BsAllMsBasicMode}

Privilege

Level

Command

Modes

Global configuration mode

NOTE

Using this command, you can disable collection of performance data for only one group at a time.

For AU, all groups must be disabled to disable collection. If at least one group is enabled, collection

will be enabled for all groups.