User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing MS in ASN-GW
4Motion 450 System Manual
3.5 Managing MS in ASN-GW
This section describes the MS level commands.
 “Manual MS De-registration”
 “Displaying MS Information”
3.5.1 Manual MS De-registration
Run the following command to initiate the de-registration process of the MS with a
specified NAI or MSID (MAC address) value, all MSs served by a specific BS or all
the MSs served by the unit.
npu(config)# de-reg ms {nai <nai-string> | bs <(1 to 16777215 StepSize 1)> | msid
<msid-string> | all}
IMPORTANT
An error may occur if NAI or MSID value is not specified. Refer to the syntax description for more
information about the appropriate values and format for configuring this parameter.
An error may occur also for “MS not found", in case no MS with the specified NAI or MSID is
registered at ASNGW.
Command
Syntax
npu(config)# de-reg ms {nai <nai-string> | bs <(1 to 16777215 StepSize 1)> | msid <msid-string> |
all}
Privilege
Level
10