User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 447 System Manual
3.4.16.8 Managing the Unique Identifier for the 4Motion Shelf
The Site Identifier (Site ID) is used by the management system as identifier of the
site and must be unique in the managed network.
The default value 0 is not a valid Site Identifier: it indicates that the Site Identifier
was not configured and a valid Site Identifier must be configured. A BTS with Site
Identifier 0 will not be discovered by AlvariSTAR.
Since the Site Identifier is used by AlvariSTAR to identify the device, it is highly
recommended not to modify it. If necessary, you must follow the Site Number
Change process described in the AlvariSTAR Device Manager User Manual.
This section describes the commands used for:
“Configuring the Unique Identifier for the 4Motion Shelf” on page 447
“Displaying the Unique Identifier for the 4Motion Shelf” on page 448
3.4.16.8.1 Configuring the Unique Identifier for the 4Motion Shelf
To configure a unique identifier for the 4Motion shelf, run the following command:
npu(config)# site identifier <site id <1-999999>>
Command
Syntax
npu# show site [{Name | Address | RackLocation | ContactPerson |ProductType }]
Privilege
Level
1
Display
Format
(for all
parameters)
Name :
Address :
Rack Location :
Contact Person :
Product Type :
Command
Modes
Global command mode