User Manual
Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 445 System Manual
3.4.16.7 Managing the Site General Information for the 4Motion Shelf
The site general parameters provide general information on the site.
This section describes the commands used for:
“Configuring the Site General Information for the 4Motion Shelf” on page 445
“Displaying the Site General Information Parameters” on page 446
3.4.16.7.1 Configuring the Site General Information for the 4Motion Shelf
Run the following command to configure the 4Motion shelf location information,
such as the rack number and location:
npu(config)# site {Name <name (32)> | Address <address(70)> |
RackLocation <rack no. + position in rack (32)> | ContactPerson
<name (32)>}
For example, run the following command if you want to specify the site name:
npu(config)# site name Site 12
Display
Format
Dry-Contact Input Alarm:
AlarmNumber AlarmName InputBlocking AlarmPolarity
<alarm num> <alarm name> <Yes or No> Raise On Close/Open
Dry-Contact Output Alarm:
AlarmNumber AlarmStatus AlarmName
<alarm num> <On or Off> <name>
Command
Modes
Global command mode
IMPORTANT
An error may occur if the length of any of these parameters exceeds the specified range. Refer the
syntax description for more information about the appropriate values and format for configuring
these parameters.