User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 444 System Manual
If you want to display configuration information for all dry contact IN alarms, run
the following command:
npu# show dry-contact IN
NOTE
An error may occur if you have specified an incorrect pin number for a particular input/output alarm.
For more information about the correct pin-to-alarm number mapping, refer
Table 3-26 and
Table 3-27.
Command
Syntax
npu# show dry-contact {IN | OUT} [<alarm_num>]
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{IN|OUT} Indicates whether
configuration information is to
be displayed for input or
output alarms.
Optional N/A
 IN
 OUT
[<alarm_num>] Denotes the alarm number of
the input or output alarm for
which configuration
information is to be displayed.
If you do not specify this
value, configuration
information is displayed for all
input or output alarms.
Refer
Figure 3-2 and
Figure 3-3 for more
information about the
numbers assigned to the pins
used for connecting dry
contact alarms.
Optional N/A
 1-8 for input
alarms
 1-3 for
output
alarms