User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 431 System Manual
In addition to the configuration parameters, the SW Versions of the GPS
Navigation and Signal Processors are also displayed (if available).
3.4.16.2.9 Displaying the Date and Time Parameters
To display the current date parameters, run the following command:
npu# show date [{Local | UTC | LocalUTCDiff | DST}]
In addition to the configurable parameters, the calculated Local Time is also
displayed.
3.4.16.2.10 Displaying the Daylight Saving Parameters
To display the current daylight saving parameters, run the following command:
npu# show daylight saving
Command
Modes
Global command mode
Command
Syntax
npu# show date [{Local | UTC | LocalUTCDiff | DST}]
Privilege
Level
1
Syntax
Description
For a detailed description of each parameter in this command, refer the section, “Configuring
the Date and Time” on page 424
.
Display
Format
Local Time :
UTC Time :
Local UTC Offset :
Daylight Saving Time :
Command
Modes
Global command mode
Command
Syntax
npu# show daylight saving