User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 426 System Manual
3.4.16.2.5 Configuring the Position
The position configuration enables setting the location’s parameters when GPS is
not used (Type=None).
To configure the position parameters, run the following command:
Command
Syntax
npu(config)# set daylight saving ([mode {Enable | Disable}] [start-date <DD.MM>] [stop-date
<DD.MM>])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
mode {Enable |
Disable}
Enables/disables the daylight
saving feature. When
enabled, the feature will be
activated using the
parameters defined below.
Optional Disable
 Enable
 Disable
start-date
<DD.MM>
Applicable only of Mode is set
to Enable. The date for
starting the daylight saving
feature: At the beginning of
this date (midnight), the clock
will be advanced by the
amount of hours specified by
the Advance Factor
parameter.
Optional 27.3 DD.MM
DD: .day in
month, 1-31.
MM .month in
year, 1-12.
stop-date
<DD.MM>
Applicable only of Mode is set
to Enable. The date for
stopping the daylight saving
feature: At the end of this
date (midnight plus the
amount of hours specified by
the Advance Factor
parameter), the clock will be
set back to midnight (00:00).
Optional 28.11 DD.MM
DD: .day in
month, 1-31.
MM .month in
year, 1-12.
Command
Modes
Global configuration mode