User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 425 System Manual
3.4.16.2.4 Configuring the Daylight Saving Parameters
To configure the daylight saving parameters, run the following command:
npu(config)# set daylight saving ([mode {Enable | Disable}]
[start-date <DD.MM>] [stop-date <DD.MM>])
IMPORTANT
An error may occur if :
1) UTC time is not in the valid format i.e. hh: mm: ss, dd/mm/yyyy.
2) Local UTCDiff is not valid format i.e. +/-hh:mm
3) Local UTC Diff is out of the range between -12 to +13 or it is not in steps of 30 minutes.
4) DST is out of range i.e between 0 to 2
Command
Syntax
npu(config)# set date [UTC <HH:MM:SS,DD/MM/YYYY>] [LocalUTCDiff <+/-HH:MM>] [DST
<(0-2)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
UTC
<HH:MM:SS,DD/M
M/YYYY>
Indicates the UTC time to be
used for 4Motion if not
available from GPS.
Optional N/A Use the format:
HH:MM: SS,
DD/MM/YYYY
LocalUTCDiff
<+/-HH:MM>
The local offset from UTC Optional +00:00 +/-HH:MM
HH: -12 to +13
MM: 00 or 30
DST <(0-2)> Applicable only of
daylightSavingMode is set to
Enable. Daylight Saving Time
offset of the local clock
Optional 0 0-2
Command
Modes
Global configuration mode
IMPORTANT
An error may occur if any of the configured value is not in a valid format: