User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 543 System Manual
npu(config-bs-66053-bs-68000)# no requiredcnr [ack] [cqi] [cdma] [qpsk-1by2]
[qpsk-3by4] [qam16-1by2] [qam16-3by4] [qam64-1by2] [qam64-2by3]
[qam64-3by4] [qam64-5by6]
You can restore only some parameters to their default values by specifying only
those parameter. For example, to restore only the ack and cqi parameters to the
default values, run the following command:
npu(config-bs-66053-nbr-68000)# no requiredcnr ack cqi
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
To restore all Neighbor BS Required C/N Levels parameters to their default value,
run the following command:
npu(config-bs-66053-nbr-68000)# no requiredcnr
3.9.9.4 Deleting Neighbor BS Triggers/Specific BS Triggers
After enabling the Neighbor BS configuration mode you can delete previously
configured triggers or specific BS triggers:
3.9.9.4.1 Deleting Neighbor BS Triggers
To delete an entry from the neighbor BS triggers table run the following command:
npu(config-bs-66053-nbr-68000)# no <trigger-name>
NOTE
Refer to Section 3.9.9.2.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no requiredcnr [ack ] [cqi ] [cdma
] [qpsk-1by2 ] [qpsk-3by4 ] [qam16-1by2 ] [qam16-3by4 ]
[qam64-1by2 ] [qam64-2by3 ] [qam64-3by4 ] [qam64-5by6 ]
Privilege
Level
10
Command
Modes
bs neighbor bs configuration mode