User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 542 System Manual
 General (refer to Section 3.9.9.3.1)
 Required C/N Level (refer to Section 3.9.9.3.2)
3.9.9.3.1 Restoring the Default Values of Neighbor BS General Parameters
To restore one or all of the Neighbor BS non-mandatory General parameters to
their default values, run the following command:
npu(config-bs-66053-nbr-68000)# no general [syncind] [eirx-pir-max]
[paging-grp-id ] [nbr-strt-rng-codes ] [bsNeighborBsDlDataMIMOMode ]
You can restore only some parameters to the default values by specifying only
those parameters. For example, to restore only the syncind to the default value,
run the following command:
npu(config-bs-66053-nbr-68000)# no general syncind
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-nbr-68000)# no general
3.9.9.3.2 Restoring the Default Values of Neighbor BS Required C/N Level
Parameters
To restore some or all of the Neighbor BS Required C/N Levels parameters to their
default values, run the following command:
NOTE
Refer to Section 3.9.9.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no general [syncind ] [eirx-pir-max
][paging-grp-id ][nbr-strt-rng-codes][bsNeighborBsDlDataMIMOMode
]
Privilege
Level
10
Command
Modes
bs neighbor bs configuration mode