User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 537 System Manual
3.9.9.2.2 Configuring the Neighbor BS Required C/N Level Parameters
The Neighbor BS Required C/N Levels table enables defining the Carrier to Noise
Ratios required for various types of transmissions.
The configured values should be the same as those defined for the applicable
Power Control Required C/N Level parameters (see Section 3.9.4.5.3) in the
neighbor BS.
To configure the Neighbor BS Required C/N Levels, run the following command:
npu(config-bs-66053-nbr-68000)# requiredcnr [ack <(-20 to 50 StepSize 1)>]
[cqi <(-20 to 50 StepSize 1)>] [cdma <(-20 to 50 StepSize 1)>] [qpsk-1by2 <(-20 to
50 StepSize 1)>] [qpsk-3by4 <(-20 to 50 StepSize 1)>] [qam16-1by2 <(-20 to 50
StepSize 1)>] [qam16-3by4 <(-20 to 50 StepSize 1)>] [qam64-1by2 <(-20 to 50
StepSize 1)>] [qam64-2by3 <(-20 to 50 StepSize 1)>] [qam64-3by4 <(-20 to 50
StepSize 1)>] [qam64-5by6 <(-20 to 50 StepSize 1)>]
[nbr-strt-rng-codes
<(0 to 255 StepSize
1)> ]
The neighbor BS
starting number; S; of
the group of codes
used for this uplink.
Should be taken from
Ranging General,
start-of-rng-codes
parameters of the
relevant BS (see
Section 3.9.19.2)
Optional 0 0 -255
[bsNeighborBsDlD
ataMIMOMode
{matrixAorB |
beamforming} ]
The diversity mode
used by the neighbor
BS. Should be taken
from Airframe
dldiversity mode
parameter of the
relevant BS (see
Section 3.9.12.2.3)
Optional matrixA0rB
 matrixAorB
 beamforming
Command
Modes
bs neighbor bs configuration mode