User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 533 System Manual
3.9.9.2 Configuring Neighbor BS Parameters
After enabling the Neighbor BS configuration mode you can configure the
following parameters tables:
 General (refer to Section 3.9.9.2.1)
 Required C/N Level (refer to Section 3.9.9.2.2)
 Triggers (refer to Section 3.9.9.2.3)
 Specific BS Triggers (refer to Section 3.9.9.2.4
3.9.9.2.1 Configuring General Neighbor BS Parameters
The General Neighbor BS Parameters table enables defining the general
parameters of the Neighbor BS.
To configure the General Neighbor BS parameters, run the following command:
npu(config-bs-66053-nbr-68000)# general [syncind {unsynchronized |
timeSynchronized | timeAndFrequencySynchronized}] [eirp <(-128 to 127
StepSize 1)>] [bw {fiveMHz | tenMHz | sevenMHz}] [feedbackzone-permbase <(0 to
69 StepSize 1)>] [ucd-configchangecount <(0 to 255 StepSize 1)>]
[dcd-configchangecount <(0 to 255 StepSize 1)>] [eirx-pir-max <(-140 to -40
StepSize 1)>] [frequency <(2022.5 to 2217.5 StepSize 0.125) | (2302.5 to 2397.5
StepSize 0.125) | (2487.5 to 2687.5 StepSize 0.125) | (3302.5 to 3397.5 StepSize
0.125) | (3402.5 to 3597.5 StepSize 0.125) | (3602.5 to 3797.5 StepSize 0.125)>]
[preamble-idx <(0 to 255 StepSize 1)>] [paging-grp-id <(0 to 65535 StepSize 1)> ]
[nbr-strt-rng-codes <(0 to 255 StepSize 1)> ] [bsNeighborBsDlDataMIMOMode
{matrixAorB | beamforming} ]
IMPORTANT
After completing the Neighbor BS configuration, do not forget to execute the apply command before
exiting the Neighbor BS configuration mode:
npu(config-bs-66053-nbr-68000)# apply
IMPORTANT
When creating a new Neighbor BS, all mandatory Neighbor BS General parameters must be
configured.