User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 531 System Manual
3.9.9 Managing Neighbor BSs
1 Enable the Neighbor BS configuration mode for the selected Neighbor BS (refer
to Section 3.9.9.1)
2 You can now execute any of the following tasks:
» Configure one or more of the parameters tables of the Neighbor BS (refer to
Section 3.9.9.2)
» Restore the default values of parameters in one or more of the parameters
tables of the Neighbor BS (refer to Section 3.9.9.3)
» Terminate the Neighbor BS configuration mode (refer to Section 3.9.9.5)
In addition, you can, at any time, display configuration information for each of the
parameters tables of the Neighbor BS (refer to Section 3.9.9.7) or delete an
existing Neighbor BS (refer to Section 3.9.9.6).
3.9.9.1 Enabling the Neighbor BS Configuration Mode\Creating a
Neighbor BS
To configure the parameters of a Neighbor BS, first enable the Neighbor BS
configuration mode for the specific Neighbor BS. Run the following command to
enable the Neighbor BS configuration mode. You can also use this command to
create a new Neighbor BS.
npu(config-bs-66053)# nbr <(1 to 16777215 StepSize 1)>
Note that for a new Neighbor BS this command only defines the Neighbor BS ID,
and that the Neighbor BS is not fully created until completing configuration of all
mandatory parameters and executing the apply command (must be executed
before exiting the Neighbor BS configuration mode). Also when updating an
existing Neighbor BS, the apply command must be executing prior to termination
the Neighbor BS configuration mode.
For example, to define a new Neighbor BS with a BS ID 66055, or to enable the
configuration mode for Neighbor BS 66055, run the following command:
npu(config-bs-66053)# nbr 66055
To configure a Neighbor BS: