User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 520 System Manual
3.9.5.2 Restoring the Default Values of the Feedback Allocation
Parameter
To restore the ir-cdma non-mandatory parameter to the default values, run the
following command:
npu(config-bs-66053)# no feedbackalloc [ir-cdma]
To restore the ir-cdma parameter to the default value, run any of the following
commands:
npu(config-bs-66053)# no feedbackalloc ir-cdma
npu(config-bs-66053)# no feedbackalloc
3.9.5.3 Displaying Configuration Information for the Feedback
Allocation Parameter
To display configuration information for Feedback Allocation parameter, run the
following command:
npu# show feedbackalloc bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Feedback Allocation parameter of BS 66053, run the
following command:
npu# show feedbackalloc bs 66053
Command
Modes
bs configuration mode
NOTE
Refer to Section 3.9.5.1 for a description and default values of this parameter.
Command
Syntax
npu(config-bs-66053)# no feedbackalloc [ir-cdma ]
Privilege
Level
10
Command
Modes
bs configuration mode