User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 410 System Manual
3.4.15.2.2 Deleting an Entry for the Trap Manager
To delete a Trap Manager, run the following command:
npu(config)# no trap-mgr ip-source <ip_addr>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ip_addr> Indicates the IP address of
the Trap Manager to be
added or modified.
Must be unique (the same IP
address cannot be assigned
to more than one Manager)
Mandatory N/A Valid IP
address
[Port
<(0-65535)>]
Indicates the port number on
which the Trap Manager will
listen for messages from the
Agent.
Optional 162 0-65535
[TrapCommunity
<string>]
Indicates the name of the
community of the Trap
Manager.
Optional public String (up to 10
characters and
case-sensitive)
[EnableFlag<integ
er(1 for enable, 2
for disable)>]
Indicates whether traps
sending to the Trap Manager
is to be enabled. or disabled
Optional 1
 1: Indicates
enable
 2 Indicates
disable
Command
Modes
Global configuration mode
IMPORTANT
A route to forward traps to a configured Trap Manager IP address must exist. For details refer to
“Configuring Static Routes” on page 192..
IMPORTANT
An error may occur if the IP address you have specified does not exist.