User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs

4Motion 512 System Manual

To restore all Target Noise and Interference Level parameters to their default

value, run the following command:

npu(config-bs-66053-pwrctrl)# no nilevels

3.9.4.3.2 Restoring the Default Values of Power Control Required C/N Level

Parameters

To restore some or all of the Required C/N Levels parameters to their default

values, run the following command:

npu(config-bs-66053-pwrctrl)# no requiredcnr [ack] [cqi] [cdma] [qpsk-1by2]

[qpsk-3by4] [qam16-1by2] [qam16-3by4] [qam64-1by2] [qam64-2by3]

[qam64-3by4] [qam64-5by6]

You can restore only some parameters to their default values by specifying only

those parameter. For example, to restore only the ack and cqi parameters to the

default values, run the following command:

npu(config-bs-66053-pwrctrl)# no requiredcnr ack cqi

These parameters will be restored to their default value, while the other

parameters will remain unchanged.

To restore all Required C/N Levels parameters to their default value, run the

following command:

npu(config-bs-66053-pwrctrl)# no requiredcnr

NOTE

Refer to Section 3.9.4.2.1 for a description and default values of these parameters.

Command

Syntax

npu(config-bs-66053-pwrctrl)# no nilevels [target-ni]

[allowed-if-level]

Privilege

Level

Command

Modes

bs power control configuration mode

NOTE

Refer to Section 3.9.4.2.2 for a description and default values of these parameters.