User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 409 System Manual
3.4.15.2 Configuring the Trap Manager
The SNMP Agent can send traps to multiple Trap Managers, for which an entry
exists in the 4Motion system. After you have created an entry for a Trap Manager,
you are required to enable the Trap Manager. You can, at any time, disable a Trap
Manager for the 4Motion system.
This section describes the commands for:
 “Adding/Modifying a Trap Manager entry” on page 409
 “Deleting an Entry for the Trap Manager” on page 410
 “Enabling/Disabling the Trap Manager” on page 411
 “Displaying Configuration Information for Trap Managers” on page 412
 “Displaying the Trap Rate Limit” on page 413
3.4.15.2.1 Adding/Modifying a Trap Manager entry
You can configure up to five Trap Manager entries for the 4Motion system. To add
a Trap Manager entry, or to modify an existing entry, run the following command:
npu(config)# trap-mgr ip-source <ip_addr> [Port <(0-65535)>]
[TrapCommunity <string>] [EnableFlag <integer(1 for enable, 2 for
disable)>]
You can view configuration information for existing Trap Managers. For details,
refer Section 3.4.15.2.4.
IMPORTANT
An error may occur if :
 You have specified invalid values for the IP address, Trap Community or port.
 The IP address is already configured for another Trap Manager.
 You are trying to create more than five Trap Managers. (You can configure up to five Trap
Managers for the 4Motion system.
Command
Syntax
npu(config)# trap-mgr ip-source <ip_addr> [Port <(0-65535)>] [TrapCommunity <string>]
[EnableFlag <integer(1 for enable, 2 for disable)>]