User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 507 System Manual
3.9.4.2 Configuring Power Control Parameters
After enabling the Power Control configuration mode you can configure the
following parameters tables:
 Target Noise and Interference Level (refer to Section 3.9.4.2.1)
 Required C/N Level (refer to Section 3.9.4.2.2)
3.9.4.2.1 Configuring Power Control Target Noise and Interference Level
Parameters
The Target Noise and Interference Level table enables defining the target limits for
various noise and interference levels.
To configure the Target Noise and Interference Levels, run the following command:
npu(config-bs-66053-pwrctrl)# nilevels [target-ni <(-130 to -110 StepSize 1)>]
[allowed-if-level {veryHigh | high | medium | low} ]
]
Privilege
Level
10
Command
Modes
bs configuration mode
NOTE
In the current release, the command for configuring Maximum EIRxP parameter,
npu(config-bs-66053-pwrctrl)# maxeirxp, is not applicable and should not be used. An attempt to
configure a value using this command will be ignored (value is taken from vendor file).
NOTE
An attempt to configure the cqi-ack-ranging parameter will be ignored. The value of this parameter
is set by internal logic.
Command
Syntax
npu(config-bs-66053-pwrctrl)# nilevels [target-ni <(-130 to -110
StepSize 1)> ] [allowed-if-level {veryHigh | high | medium | low}
]
Privilege
Level
10