User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 506 System Manual
3.9.4 Managing Power Control Levels
1 Enable the Power Control configuration mode (refer to Section 3.9.4.1)
2 You can now execute any of the following tasks:
» Configure one or more of the Power Control parameters tables (refer to
Section 3.9.4.2)
» Restore the default values of parameters in one or more of the Power
Control parameters tables (refer to Section 3.9.4.3)
» Terminate the Power Control configuration mode (refer to Section 3.9.4.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables (refer to Section 3.9.4.5).
3.9.4.1 Enabling the Power Control Configuration Mode
To configure the Power Control parameters, first enable the Power Control
configuration mode. Run the following command to enable the Power Control
configuration mode.
npu(config-bs-66053)# pwrctrl
The Power Control configuration mode is enabled, after which you can execute
any of the following tasks:
 Configure one or more of the Power Control parameters tables (refer to
Section 3.9.4.2)
 Restore the default values of parameters in one or more of the parameters
tables (refer to Section 3.9.4.3)
After executing the above tasks, you can terminate the Power Control
configuration mode (refer to Section 3.9.4.4) and return to the BS configuration
mode.
To configure the Power Control Levels:
Command
Syntax
npu(config-bs-66053)# pwrctrl