User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration

4Motion 190 System Manual

3.4.8.2.4 Terminating the ACL Configuration Mode

To terminate the ACL configuration mode, run the following command:

npu(config-ext-nacl) # exit

3.4.8.3 Enabling/Disabling QoS Marking for ACL 199

You can enable/disable the QoS marking for the ACL. The class-map is applied on

traffic matching a QoS classification rule only after you enable the QoS marking

for the ACL).

Run the following command to enable/disable the QoS marking for the specified

ACL:

npu(config)# set qos {enable | disable} 199

Command

Modes

Extended ACL configuration mode

Command

Syntax

npu(config-ext-nacl) # exit

Privilege

Level

Command

Modes

Extended ACL configuration mode

NOTE

If you want to modify a QoS class-map, first disable the QoS marking rules for the associated ACL.

By default, QoS marking is disabled for the ACL.

Command

Syntax

npu(config)# set qos {enable | disable} 199

Privilege

Level