User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 187 System Manual
After configuring QoS classification rules for this ACL, enable QoS marking for
this ACL. By default, QoS marking is disabled. For details, refer to Section 3.4.8.3.
Run the following command to configure a QoS classification rule for this ACL:
npu(config-ext-nacl)# qos-mark {{host <src-ip-address>} {{tcp |
udp} srcport <short (1-65535)>} qosclassifier <short (1-65535)>}
When you execute this command, a new QoS classification rule is added to the
ACL for which the configuration mode is enabled.
Bearer MobileIP-Agent UDP 434 2 7 7
Bearer WiMAX ASN
Control Plane
Protocol
UDP 2231 3 7 7
Internal-Management OBSAI message
exchange
between NPU
and AU
UDP 10009 4 0 0
Internal-Management Trivial File
Transfer Protocol
UDP 69 5 0 0
External-Management Telnet TCP 23 6 0 0
External-Management SSH Remote
Login Protocol
TCP 22 7 0 0
External-Management SNMP UDP 161 8 0 0
IMPORTANT
An error may occur if:
 You have specified a source port that is not within the range, 1-65535.
 The host IP address or class-map identifier that you have specified do not exist.
Command
Syntax
npu(config-ext-nacl)# qos-mark {{host <src-ip-address>} {{tcp | udp} srcport <short (1-65535)>}
qosclassifier <short (1-65535)>}
Privilege
Level
10
Table 3-15: Pre-Configured QoS Classification Rules and Class-Maps
IP Interface Type of Traffic Protocol Source
Port
Class
Map
DSCP 802.1p