User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing Software Upgrade
4Motion 108 System Manual
npu(config)# software version server <server ip>
3.2.3.1.2 Step 2: Downloading the AU Image to the NPU Flash
After the TFTP server is configured, run the following command to download the
AU image (to be used for software upgrade) to the NPU flash:
npu(config)# Download AU image <AU image name>
After you execute this command, the AU image is downloaded to the NPU flash.
IMPORTANT
An error may occur if you execute this command when another software download is already in
progress.
Command
Syntax
npu(config)# software version server <server ip>
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<server ip>
Denotes the IP address of the
TFTP server to be used for
the software version
download.
Mandatory N/A Valid IP
address
Command
Modes
Global configuration mode
IMPORTANT
The NPU flash can store a maximum of three AU images. If you download a new AU image to the
NPU flash, the oldest image (that is not used for any mapping) is overwritten. To delete an AU
image that is used for mapping, you must first delete the AU-to-image mapping. For details, refer to
“Deleting the AU-to-Image Mapping” on page 116. It is recommended that you frequently
delete AU images that are no longer required, from the NPU flash. For details, refer to
“Displaying Images Residing in the Flash” on page 118.