User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 151 System Manual
3.4.2.3.8 Testing Connectivity to an IP Interface
To test connectivity to an IP interface, perform a ping test using the following
command:
npu# ping <ip-address> [timeout <seconds(1-15)>] [count
<count(1-20)>]
Command
Modes
Global command mode
IMPORTANT
An error may occur if the specified IP address does not match any of the available IP interfaces.
Command
Syntax
npu#
ping <ip-address> [timeout <seconds(1-15)>] [count <count(1-20)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible Values
<ip-address> Indicates the interface for
which a ping connectivity
test should be performed.
Mandatory N/A IP address of an
host IP interface
timeout
<seconds(1-15)>
The maximum time in
seconds to wait for a
response before sending
another packet or
terminating the test
Optional 5 1-15
count <count(1-20)> The number of packets to
be sent.
Optional 5 1-20
Command
Modes
Global command mode