User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 149 System Manual
3.4.2.3.6 Terminating the Interface Configuration Mode
To terminate the interface configuration mode, run the following command:
npu(config-if)# exit
IMPORTANT
An error may occur if:
 The VLAN ID you have specified is not within the specified range, or is in use by another
interface. Refer the syntax description for the VLAN ID range.
 The VLAN ID is already used as a translated VLAN or a VLAN translation entry already exists
for this VLAN.
 You are trying to run this command for the internal-management interface. You can modify the
VLAN ID for only the external-management, local-management or bearer interfaces.
Command
Syntax
npu(config-if)# if_vlan <vlanid(9 | 11-100 | 110-4094)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<vlanid(9 | 11-100 |
110-4094)
Indicates the VLAN ID to be
assigned to this interface.
Note: The VLAN IDs, 1-8, 10,
101-109 are reserved.
Mandatory N/A
 9
 11-100
 110-4094
Command
Modes
Interface Configuration mode
Command
Syntax
npu(config-if)# exit
Privilege
Level
10