User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing Software Upgrade
4Motion 104 System Manual
3.2.2.3 Displaying the TFTP Configuration Information
You can, at any time (during or after the download procedure), run the following
command to view the configuration information about the TFTP server that is
used for the NPU software upgrade:
npu# show software version server
NOTE
The operational version is the default software version that is used for rebooting the NPU after
system reset.
The shadow version is the downloaded software version that you can use to boot up the NPU.
However, it is the operational software version that is used to boot up the NPU after the next system
reset.
The running version is the software version (can be either the operational or shadow version) that is
currently running on the system.
Command
Syntax
npu# show software version npu
Display
Format
Mananged Object : NPU
Operational Version : <Operational Version>
Shadow Version : <Shadow Version>
Running Version : <Running Version>
Command
Modes
Global command mode
IMPORTANT
An error may occur if configuration information is requested for a TFTP server that is not configured.
For more information about configuring the TFTP server to be used for software download, refer to
“Step 1: Configuring the TFTP Server” on page 100.
Command
Syntax
npu# show software version server
Display
Format
Software version server <Server IP Address>